Advances in large area polycrystalline solar cellsPolycrystaline silicon is presently routinely processed into low cost 10 cm by 10 cm solar cells. However assuming minimal handling difficulties, only minor equipment modifications and no increase in processing complexity, the fabrication of even larger geometries would be economically advantageous. This investigation addressed the feasibility of developing 10 cm by 15 cm solar cells from research through pilot line production stages. The major thrust was to minimize costing by using existing production equipment and proven techniques wherever possible. Accordingly methods were developed to section larger substrates from existing cast ingots, a simple solar cell was designed and low cost processes implemented. After numerous preliminary experiments, pilot line production of 1500 cells was completed. Of these approximately 62 percent exhibited efficiencies greater than 7.0 percent, 53 percent were greater than 8.0 percent and 15 percent were greater than 9.0 percent. Based on this study, the regular production of 10 cm by 15 cm solar cells was determined to be both feasible and cost effective using existing processing methods.
Document ID
19850029277
Acquisition Source
Legacy CDMS
Document Type
Conference Paper
Authors
Vendura, G. J., Jr. (Pennsylvania State University University Park, PA; Solarex Corp., Rockville, MD, United States)
Johnson, G. (Pennsylvania State Univ. University Park, PA, United States)
Hoelscher, J. F. (Solarex Corp. Rockville, MD, United States)