Influence of contraction section shape and inlet flow direction on supersonic nozzle flow and performance.

Wall static pressure measurements and performance parameters are presented for axisymmetric supersonic nozzles with relatively steep convergent sections and comparatively small radius-of-curvature throats. The nozzle walls were essentially adiabatic. These results are compared with those obtained in other nozzles tested previously to appraise the influence of contraction shape on performance. Both the flow coefficient and the thrust were less than the corresponding values for one-dimensional, isentropic, plane flow for both the axial and radial inflow nozzles considered, but the specific impulse, the most important performance parameter, was found to be relatively unchanged. The thrust decrement for the axial inflow nozzles was established primarily by the shape of the contraction section, and could be estimated reasonably well from a conical sink flow consideration. The radial inflow nozzle has a potential advantage from a cooling point of view if used in a rocket engine.