Investigation to develop a multistage forest sampling inventory system using ERTS-1 imagery

The author has identified the following significant results. Two strips of U-2 RC-10 images were analytically triangulated and adjusted. Control points and pass points were marked on glass plates made from B&W copy negatives of IR color transparencies. A wild PUG-3 and TA1/p monocomparator were used to mark and measure the points on the glass plates. Each plate was measured twice in the same orientation for a check on accuracy and operator error. The 22 photographs were adjusted to 41 ground control and tie points and the block adjustment was performed in a secant plane coordinate system to eliminate the effect of earth curvature. Standard deviations of the residuals of the control and tie points were 12.8 m, 10.8 m, and 4.5 m for the X, Y, and Z coordinates respectively. The 12.8 m and 10.8 m figures correspond to an identification accuracy of 0.1 mm on the U-2 RC-10 plates. The standard deviations of the residuals encountered in the ERTS-1 resectioning were: (1) 0.16 mm assuming uncorrected perspective geometry and (2) 0.12 mm when the polynomial adjustment was added in. These results indicate a reduction of 0.11 in the square error due to the polynomial adjustment.