A new technique for inducing a turbulent boundary layer in a supersonic flow

The feasibility of using slot injection to establish a turbulent boundary layer corresponding to a known Reynolds number was investigated. The basic concept consists of injecting secondary air through a slot. The air is injected at the same local static pressure at a selected stagnation temperature to simulate a given up-stream heat conduction. The mass of the injected air is controlled to match a desired Reynolds number. Secondary air was injected through a supersonic nozzle over a flat plate model. Tests were conducted with different injection air conditions. Heat transfer rates were measured behind the slot and results were compared with theoretical estimates. Static pressure measurements were made over the surface in the streamwise direction. Velocity and Mach number profiles were determined downstream of the slot. Laminar and turbulent profiles were calculated to compare with the results of measurements. Experimental results indicate that this is an effective method for establishing a turbulent boundary layer having a prescribed value of R sub e Theta.