Quantification of Geologic Lineaments by Manual and Machine Processing Techniques

The effect of operator variability and subjectivity in lineament mapping and methods to minimize or eliminate these problems by use of several machine preprocessing methods was studied. Mapped lineaments of a test landmass were used and the results were compared statistically. The total number of fractures mapped by the operators and their average lengths varied considerably, although comparison of lineament directions revealed some consensus. A summary map (785 linears) produced by overlaying the maps generated by the four operators shows that only 0.4 percent were recognized by all four operators, 4.7 percent by three, 17.8 percent by two, and 77 percent by one operator. Similar results were obtained in comparing these results with another independent group. This large amount of variability suggests a need for the standardization of mapping techniques, which might be accomplished by a machine aided procedure. Two methods of machine aided mapping were tested, both simulating directional filters.