Missile impact craters (White Sands Missile Range, New Mexico) and applications to lunar research: Contributions to astrogeology

Craters in natural materials at White Sands Missile Range, N. Mex., were produced by the impact of high-velocity to hypervelocity missiles traveling along oblique trajectories with kinetic energies between 2.1 and 81 × 1014 ergs. The oblique impacts produce craters 2 to 10 m across with morphologies and ejecta that are bilaterally symmetrical with respect to the plane of the missile trajectory. Rims are high and the amount of ejecta large in down-trajectory and lateral directions, whereas rims are low to nonexistent and ejecta thin to absent up-trajectory. Symmetry development and modifications of the symmetry are a function of target material, local topography, and angle of impact.

Seven mappable units can be recognized in and around the craters. Three of these are ejecta: thick ejecta near the crater, thin to discontinuous ejecta at greater distances, and scattered ejecta at the greatest distances to the limit of throwout. These ejecta units may be absent on the up-trajectory side; if present, they are rarely as thick or continuous as on other sides of the crater. Three units are target materials: undeformed target material exposed in local patches through thin to discontinuous ejecta and everywhere between the fragments of scattered ejecta, tilted and broken target material exposed in upper crater walls, and shattered and fractured target material exposed on the up-trajectory crater wall. The seventh unit is slope material composed of talus and fallback within the crater. Development, character, and exposure of these units varies chiefly with the target material.

Ejecta from the craters is chiefly broken but relatively undeformed target material that may range in size from very fine grained debris to large blocks. Where the target is porous, significant amounts of the ejecta are composed of sheared and compressed fragments, some coated with dark layers of mixed projectile pieces, powder, and fused metal mixed with crushed target material. For layered targets, the original stratigraphic sequence is crudely preserved and in inverted order in thick ejecta.

Secondary impact craters are produced by the impact of ejected fragments when the surrounding surface materials are sufficiently weak. A wide variety of secondary impact crater relations may result. Secondary craters nearest the primary crater have blocks in them that are larger than or the same size as the crater they produced. Farther from the primary crater, the fragments are generally smaller than the secondary crater and are ejected from it.

Excavation of four craters revealed a mixed breccia beneath the crater floor composed of missile pieces, sheared and compressed target material, and crushed debris. Banded, disaggregated target material and nonmixed breccia surrounded the mixed breccia, and these breccias were surrounded by a zone of conjugate fractures. Beneath the ejecta on the lateral and down-trajectory crater flanks, the target materials were tilted upward and broken. Up-trajectory, open fractures and downward displacement occurred in two of the craters. No displacement was observed for the other two.

Beneath the down-trajectory rims of craters with distinct layering, overturned synclines were observed.

Missile breakup and behavior during cratering are a function of target and missile properties. Missile breakup depends on missile velocity and is most extensive at high velocities, where the missile is fragmented, powdered, and partly fused. Burial of missile or its fragmented, powdered, and fused remains is greatest for porous targets and least for dense cohesive targets. For very porous targets, camouflet structures containing the fragmented missile may form.

Least squares fit to the data on craters in dry to moist targets indicate

V(a) = 10^(-11.433)E(p)^(1.205)

where V(a) is the volume of the apparent crater and E(p) is the kinetic energy of the missile. This equation is consistent with expectations of the equations relating apparent depth and radius to kinetic energy. Extrapolation of displaced masses and kinetic energies for laboratory impacts with sand and rock converge near 10^(15) to 10^(16) ergs, where the extrapolations are near the data on missile impact craters, corrected for impact angle.

Displaced masses of craters produced by missile impacts and by chemical explosives with small scaled depths of burial are about the same when the kinetic energies of the missiles (corrected for angle of impact) are equal to the TNT equivalent energy of the explosive. The
problem of equivalent scaled depth of burst for an impact crater is complicated and not entirely resolved, however. Both missile impact craters and chemical explosive craters in water-saturated targets are larger than their counterparts in dry to moist materials.

Data collected during the study of missile impact craters have helped resolve a number of problems in lunar research: (1) the soillike nature of lunar surface materials was predicted, (2) sizes of craters produced by artificial impacts were correctly predicted, (3) certain features imaged by Surveyor were found to be analogous to features associated with missile impact craters, {4) missile impacts were used in support of the Apollo passive seismic experiment, (5) craters seen in Apollo orbital photographs were found to be similar to some missile impact craters, (6) missile impact craters supplied data on sample collection and crater phenomenology used in training astronauts, and (7) some returned lunar samples are similar to coated, sheared, and compressed fragments ejected from missile impact craters.