Implicit multigrid algorithms for the three-dimensional flux split Euler equations

The full approximation scheme multigrid method is applied to several implicit flux-split algorithms for solving the three-dimensional Euler equations in a body fitted coordinate system. Each uses a variation of approximate factorization and is implemented in a finite volume formulation. The algorithms are all vectorizable with little or no scalar computations required. The flux vectors are split into upwind components using both the splittings of Steger-Warming and Van Leer. Results comparing pressure distributions with experimental data using both splitting types are shown. The stability and smoothing rate of each of the schemes are examined using a Fourier analysis of the complete system of equations. Results are presented for three-dimensional subsonic, transonic, and supersonic flows which demonstrate substantially improved convergence rates with the multigrid algorithm. The influence of using both a V-cycle and a W-cycle on the convergence is examined. Using the multigrid method on both subsonic and transonic wing calculations, the final lift coefficient is obtained to within 0.1 percent of its final value in a few as 15 cycles for a mesh with over 210,000 points. A spectral radius of 0.89 is achieved for both subsonic and transonic flow over the ONERA M6 wing while a spectral radius of 0.83 is obtained for supersonic flow over an analytically defined forebody. Results compared with experiment for all cases show good agreement.