Estimation of distributed acoustic lasers

The purpose of this paper is to present the results of a preliminary investigation of an indirect method which can be used to generate a set of equivalent point loads approximating an applied distributed acoustic load. The method combines the source information with the structure's modal characteristics and forces which give the same response as the applied acoustic load. The technique is demonstrated by predicting a set of point forces acting on a thin aluminum panel which simulate a normally-incident random pressure. The technique is verified by comparing measured strain autospectrums with estimated strain autospectrums generated using the predicting forces. Strain errors within 5 dB were achieved. A limited amount of information about the acoustic load could be deduced using the predicted force autospectrums and phase differences between these forces.