NASA Logo

NTRS

NTRS - NASA Technical Reports Server

The auto‑search feature has been disabled based on user feedback. Enter a search term/phrase and click “Search” to begin.

Back to Results
Heat transfer measurements from a NACA 0012 airfoil in flight and in the NASA Lewis icing research tunnelLocal heat transfer coefficients from a smooth and roughened NACA 0012 airfoil were measured using a steady state heat flux method. Heat transfer measurements on the specially constructed 0.533 meter chord airfoil were made both in flight on the NASA Lewis Twin Otter Research Aircraft and in the NASA Lewis Icing Research Tunnel (IRT). Roughness was obtained by the attachment of small, 2 mm diameter, hemispheres of uniform size to the airfoil surface in four distinct patterns. The flight data was taken for the smooth and roughened airfoil at various Reynolds numbers based on chord in the range of 1.24x10(exp 6) to 2.50x10(exp 6) and at various angles of attack up to 4 degrees. During these flight tests the free stream velocity turbulence intensity was found to be very low (less than 0.1 percent). The wind tunnel data was taken in the Reynolds number range of 1.20x10(exp 6) to 4.52x10(exp 6) and at angles of attack from -4 degrees to +8 degrees. The turbulence intensity in the IRT was 0.5 to 0.7 percent with the cloud making spray off. Results for both the flight and tunnel tests are presented as Frossling number based on chord versus position on the airfoil surface for various roughnesses and angle of attack. A table of power law curve fits of Nusselt number as a function of Reynolds number is also provided. The higher level of turbulence in the IRT versus flight had little effect on heat transfer for the lower Reynolds numbers but caused a moderate increase in heat transfer at the higher Reynolds numbers. Turning on the cloud making spray air in the IRT did not alter the heat transfer. Roughness generally increased the heat transfer by locally disturbing the boundary layer flow. Finally, the present data was not only compared with previous airfoil data where applicable, but also with leading edge cylinder and flat plate heat transfer values which are often used to estimate airfoil heat transfer in computer codes.
Document ID
19900009887
Acquisition Source
Legacy CDMS
Document Type
Thesis/Dissertation
Authors
Poinsatte, Philip E.
(Toledo Univ. OH, United States)
Date Acquired
September 6, 2013
Publication Date
March 1, 1990
Publication Information
Publisher: NASA
Subject Category
Aerodynamics
Report/Patent Number
E-5228
NAS 1.26:4278
NASA-CR-4278
Report Number: E-5228
Report Number: NAS 1.26:4278
Report Number: NASA-CR-4278
Accession Number
90N19203
Funding Number(s)
PROJECT: RTOP 506-68-11
CONTRACT_GRANT: NAG3-72
Distribution Limits
Public
Copyright
Work of the US Gov. Public Use Permitted.
No Preview Available