Nonlinear aerodynamics and the design of wing tips

This report describes results of research conducted from April 1991 through March 1992. The general objective was to improve an existing wing optimization method, and apply the method to specific problems of interest. The method, while a valuable tool for wing tip design studies, can be applied to more general problems, and has been applied to some of these other problems during its development. Specific goals that were accomplished are listed and explained in more detail in the report. First, improvements were made to the portability and control flow of the existing code. The major iteration loop dealing with structural design was sped up and an alternate approach, using the optimizer to do structural sizing, was studied. Second, analysis methods were improved in the areas of structural and high lift modeling. The structural method was revised to give total wing weight and verified against data for particular commercial aircraft. The high lift analysis was improved to provide reasonable estimates of C(sub L max) in the flaps down condition. These improvements enabled making wing area a design variable, where it had been a fixed variable in the original method. Third, the method was applied to the design of wings for a Learjet. Rough studies were done to determine the effects of laminar flow design on wing shape. Finally, studies on wingtip shape were begun.