Stress Concentration Around an Open Circular Hole in a Plate Subjected to Bending Normal to the Plane of the Plate

An aluminum-alloy plate containing an open circular hole of diameter large compared with the thickness of the plate was subjected to bending forces normal to the plane of the plate. Deflection and strain measurements were taken for two different loads. Stress concentrations occurred at the edge of the hole and the maximum stresses were tangential to the hole at the ends of the transverse diameter. The maximum stress at the edge of the hole was 1.59 times the computed stress on the net section and 1.85 times the computed stress in a solid plate of the same dimensions subjected to the same bending forces. The maximum deflections were about 20 percent greater than the corresponding deflection for a solid plate of the same size subjected to the same bending forces. The smallest edge distance was equal to 2-1/2 times the diameter of the hole and the stress concentration on this side of the hole was the same as on the side where the edge distance was about 4-1/2 diameters. A theoretical analysis of the problem shows that, for an aluminum plate of infinite width, the stress concentration at the edge of the hole would be 1.87 times the stress in a solid plate, which is substantially the same relation obtained for the plate tested.