The Pressure Distribution over the Horizontal Tail Surfaces of an Airplane II

This investigation was undertaken to determine whether the results obtained upon model tail surfaces can be used to accurately predict loads upon the full-sized tail; and also to find the distribution of load when large elevator angles are used, as the loads from such angles can not be obtained readily in free flight. The method consisted in using a metal horizontal tail surface inside of which small air passages, connecting with a series of holes in the surface, led the pressure off from the tail in rubber tubes. In this way the pressure at each of these holes was measured by a manometer at several angles of attack and several to the loading under similar conditions in the full-sized airplane and the manner of distribution is quite similar in the two cases when there is no slip stream.