The Flowfield Around a STOVL Aircraft Model in Ground Effect

An experimental investigation was conducted to determine the causes of hot gas ingestion of engine inlets in STOVL and V/STOVL aircraft in ground effect. Marker nephelometry was used to establish the interactions between the jets, forward velocity, and ground for a typical aircraft model configuration. The aircraft test model consisted of a two inlet configuration with four low subsonic velocity jets impacting vertically on a flat plate. The vertical distance between the plate and model under-surface was adjustable, and a wind tunnel provided forward air velocities from 0 to 0.1 times the jet velocity to simulate landing into a wind. Single frame pictures of the smoke concentration distribution in the flowfield revealed several vortical features in the interaction region, which were affected variously by the distance between the ground plane and model, the forward wind velocity, and the inlet suction. Some of these vortical features, such as the ground vortex, have been seen before in experiments using single jets. Other vortical features in the flowfield, such as the forward vortex pair, have not been seen before. Frame-averaged experimental smoke concentration profiles compared favorably with numerical time-averaged predictions of temperature distribution carried out at the University of Illinois. However, such predictions did not seem to reveal some aspects of the vortical flow features which should affect instantaneous distortion into the engine inlet.