Performance of Several Method-of-Characteristics Exhaust Nozzles

Nozzle performance data were obtained with three "method-of-characteristics" nozzles and a 150 conical nozzle at pressure ratios up to 130. Each basic configuration was cut off and tested at expansion ratios of 25, 20, 15, and 10. Unheated dry air was used at nozzle inlet pressures up to 22,000 pounds per square foot absolute. Nozzle thrust data were extrapolated to infinite pressure ratio (zero discharge pressure). As much as 1-percent increase in thrust with no increase in nozzle surface area (weight), can be obtained by using a method-of-characteristics, nozzle instead of a 15 conical nozzle when operating with a nozzle expansion ratio of 25 and nozzle pressure ratios from 200 to infinity. Conversely, for the same thrust, reductions in nozzle divergent surface area in the order of 25 percent are possible. The thrust performance of the method-of-characteristics nozzle was not as good as that of the 150 conical nozzle when operating at pressure ratios considerably below design (below 100 for the expansion ratio 25 nozzles). Theoretical and measured nozzle momentum coefficients agreed within about 0.6 percent. This is the order of accuracy of both the measured and theoretical values.