NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
RFI and SCRIMP Model Development and VerificationVacuum-Assisted Resin Transfer Molding (VARTM) processes are becoming promising technologies in the manufacturing of primary composite structures in the aircraft industry as well as infrastructure. A great deal of work still needs to be done on efforts to reduce the costly trial-and-error methods of VARTM processing that are currently in practice today. A computer simulation model of the VARTM process would provide a cost-effective tool in the manufacturing of composites utilizing this technique. Therefore, the objective of this research was to modify an existing three-dimensional, Resin Film Infusion (RFI)/Resin Transfer Molding (RTM) model to include VARTM simulation capabilities and to verify this model with the fabrication of aircraft structural composites. An additional objective was to use the VARTM model as a process analysis tool, where this tool would enable the user to configure the best process for manufacturing quality composites. Experimental verification of the model was performed by processing several flat composite panels. The parameters verified included flow front patterns and infiltration times. The flow front patterns were determined to be qualitatively accurate, while the simulated infiltration times over predicted experimental times by 8 to 10%. Capillary and gravitational forces were incorporated into the existing RFI/RTM model in order to simulate VARTM processing physics more accurately. The theoretical capillary pressure showed the capability to reduce the simulated infiltration times by as great as 6%. The gravity, on the other hand, was found to be negligible for all cases. Finally, the VARTM model was used as a process analysis tool. This enabled the user to determine such important process constraints as the location and type of injection ports and the permeability and location of the high-permeable media. A process for a three-stiffener composite panel was proposed. This configuration evolved from the variation of the process constraints in the modeling of several different composite panels. The configuration was proposed by considering such factors as: infiltration time, the number of vacuum ports, and possible areas of void entrapment.
Document ID
20000097379
Acquisition Source
Langley Research Center
Document Type
Contractor or Grantee Report
Authors
Loos, Alfred C.
(Virginia Polytechnic Inst. and State Univ. Blacksburg, VA United States)
Sayre, Jay
(Virginia Polytechnic Inst. and State Univ. Blacksburg, VA United States)
Date Acquired
September 7, 2013
Publication Date
August 15, 2000
Subject Category
Composite Materials
Funding Number(s)
CONTRACT_GRANT: NAG1-1881
Distribution Limits
Public
Copyright
Work of the US Gov. Public Use Permitted.
No Preview Available