Temperature and Forward Flight Effects on an Underexpanded Jet Noise

An experimental investigation was carried out in the NASA Ames 40'x80' wind tunnel to investigate the far field noise characteristics of a supersonic jet exiting from an axisymmetric convergent nozzle. The nozzle geometry conforms to the ASME specifications for the long radius nozzle. The nozzle pressure ratio NPR, (stagnation pressure/ambient pressure) was varied from 2.5 to 4.5. The temperature ratio, TR (stagnation temperature/ambient temperature) was varied from 2.5 to 3.5. The resulting Reynolds number range, based on the nozzle exit diameter of 12.55cm, is from 0.98 -1.27 x 10(exp 6). The far field directivity was obtained using 1/4 inch diameter condenser microphone with the Flow-Induced Tone Eliminator (FITE) aerodynamic microphone fore body. Appropriate microphone corrections, developed by Allen et al., were made for accurate in-flow acoustic measurements at high frequencies. The narrow band (band width = 64 Hz) frequency spectra covering a range from 0 to 70 KHz were obtained with an accuracy of plus or minus 0.6dB. Typical narrow-band spectra representing far field noise in the forward quadrant, normal to the jet axis and the aft quadrant are shown. The three dominant components of the noise, the screech tone, broad-band shock associated noise and the mixing noise, are clearly identifiable in the spectra. The variation of the screech tone with the exit Mach number (calculated from the isentropic equation relating NPR to Mach number), is shown. The solid line in the figure is calculated using Tam's formula. The model developed by Tam seems to work well even at high temperatures. The appearance of the screech tone is confined to the forward quadrant (theta less than or equal to 60 degrees; the angle theta is measured from the inlet axis). The amplitude of the tone is about 10 dB higher than the broad band noise, which is less than the normally observed amplitude for cold jets operating at similar conditions.