NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
Flow and Noise Control in High Speed and High Reynolds Number Jets Using Plasma ActuatorsThe idea of manipulating flow to change its characteristics is over a century old. Manipulating instabilities of a jet to increase its mixing and to reduce its radiated noise started in the 1970s. While the effort has been successful in low-speed and low Reynolds number jets, available actuators capabilities in terms of their amplitude, bandwidth, and phasing have fallen short in control of high-speed and high Reynolds number jets of practical interest. Localized arc filament plasma actuators have recently been developed and extensively used at Gas Dynamics and Turbulence Laboratory (GDTL) for control of highspeed and high Reynolds number jets. While the technique has been quite successful and is very promising, all the work up to this point had been carried out using small high subsonic and low supersonic jets from a 2.54 cm diameter nozzle exit with a Reynolds number of about a million. The preliminary work reported in this paper is a first attempt to evaluate the scalability of the technique. The power supply/plasma generator was designed and built in-house at GDTL to operate 8 actuators simultaneously over a large frequency range (0 to 200 kHz) with independent control over phase and duty cycle of each actuator. This allowed forcing the small jet at GDTL with azimuthal modes m = 0, 1, 2, 3, plus or minus 1, plus or minus 2, and plus or minus 4 over a large range of frequencies. This power supply was taken to and used, with minor modifications, at the NASA Nozzle Acoustic Test Rig (NATR). At NATR, 32 actuators were distributed around the 7.5 in. nozzle (a linear increase with nozzle exit diameter would require 60 actuators). With this arrangement only 8 actuators could operate simultaneously, thus limiting the forcing of the jet at NATR to only three azimuthal modes m = plus or minus 1, 4, and 8. Very preliminary results at NATR indicate that the trends observed in the larger NASA facility in terms of the effects of actuation frequency and azimuthal modes are similar in both small GDTL and larger NASA jets. However, the actuation authority seems to fall short in the larger jet at higher Mach numbers, resulting in decreased amplitude response compared to the small jet, which is attributed at this point to the lack of sufficient number of actuators. The preliminary results seem also to suggest that amplitude of actuation tones is similar in both the small and larger jets.
Document ID
20070002702
Acquisition Source
Glenn Research Center
Document Type
Conference Paper
Authors
Samimy, M.
(Ohio State Univ. Columbus, OH, United States)
Kastner, J.
(Ohio State Univ. Columbus, OH, United States)
Kim, J.-H.
(Ohio State Univ. Columbus, OH, United States)
Utkin, Y.
(Ohio State Univ. Columbus, OH, United States)
Adamovich, I.
(Ohio State Univ. Columbus, OH, United States)
Brown, C. A.
(NASA Glenn Research Center Cleveland, OH, United States)
Date Acquired
August 24, 2013
Publication Date
December 1, 2006
Subject Category
Fluid Mechanics And Thermodynamics
Report/Patent Number
NASA/TM-2006-214367
AIAA Paper 2006-2846
E-15645
Meeting Information
Meeting: Third Flow Control Conference
Location: San Francisco, CA
Country: United States
Start Date: June 5, 2006
End Date: June 8, 2006
Sponsors: American Inst. of Aeronautics and Astronautics
Funding Number(s)
CONTRACT_GRANT: NCC3-1086
WBS: WBS 754.02.07.03.04.02
Distribution Limits
Public
Copyright
Work of the US Gov. Public Use Permitted.
No Preview Available