Testing and Maturing a Mass Translating Mechanism for a Deep Space CubeSat

Near Earth Asteroid (NEA) Scout is a deep space satellite set to launch aboard NASA’s Exploration Mission 1. The spacecraft fits within a CubeSat standard 6U (about 300 x 200 x 100 mm) and is designed to travel 1 AU over a 2.5 year mission to observe NEA VG 1991. The spacecraft will use an 86 square meter solar sail to maneuver from lunar orbit to the NEA. One of the critical mechanisms aboard NEA Scout, the Active Mass Translator (AMT), has gone through rigorous design and test cycles since its conception in July of 2015. The AMT is a two-axis translation table required to balance the spacecraft’s center of mass (CM) and solar sail center of pressure (CP) while also trimming disturbance torque created by off-nominal sail conditions. The AMT has very limited mass and volume requirements, but is still required to deliver a large translation range—about 160 x 68 mm—at sub mm accuracy and precision. The system must accommodate and protect a shielded wire harness and coax cables during translation. Lastly, the system has been constrained to operate in complete exposure to space with limited power and data budgets for mechanical and thermal needs. The NEA Scout team has developed and carried out a rigorous test suite for the prototype and engineering development unit (EDU). These tests uncovered numerous design failures and led to many failure investigations and iteration cycles. This paper will site each discovery and discuss at length the most surprising and difficult failures to date as the NEA Scout AMT moved through functional, random vibration, thermal vacuum, harnessing, and design life verification testing. A paper was previously presented at the 43rd Aerospace Mechanisms Symposia entitled, “Development of a High Performance, Low Profile Translation Table with Wire Feedthrough for a Deep Space CubeSat”. This paper will make note of specific lessons learned from the test activities: testing ideologies for high-risk missions, thermal mitigation design for small mechanisms, non-flight qualified stepper motor accommodation, harnessing volume allocation/design, and ground testing of mechanisms developed for zero-g environments.