NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
Investigation of Atmospheric Boundary-Layer Effects on Launch-Vehicle Ground Wind LoadsA launch vehicle ground-wind-loads program is underway at the NASA Langley Transonic Dynamics Tunnel. The objectives are to quantify key aerodynamic and structural characteristics that impact the occurrence of large wind-induced oscillations of a launch vehicle when exposed to ground winds prior to launch. Of particular interest is the dynamic response of a launch vehicle when a von Kármán vortex street forms in the wake of the vehicle resulting in quasiperiodic lift and drag forces. Vehicle response to these quasiperiodic forces can become quite large when the frequency of vortex shedding nears that of a lowly-damped structural mode thereby exciting a resonant response. Wind approaching the vehicle can be characterized by a varying speed with height and turbulence content. The combination of both the varying speed and turbulence content is referred to herein as the atmospheric boundary-layer. The importance of the atmospheric boundary-layer upon launch vehicle wind-induced oscillation response has long been questioned, and its effects are not well understood. Although there are several facilities around the world dedicated to replicating atmospheric boundary layers, the development of such a boundary layer in a wind tunnel capable of producing flight-representative Reynolds numbers for aeroelastically-scaled launch vehicle models has only recently been accomplished. The NASA Langley Transonic Dynamics Tunnel is capable of simulating flight-representative Reynolds numbers of launch vehicles on the pad and is uniquely capable of replicating many fluid-structure scaling parameters typical of aeroelastic tests. Recent test efforts successfully developed representative atmospheric boundary-layers for three launch sites in the Transonic Dynamics Tunnel, thereby allowing all known aerodynamic and fluid-structure coupling parameters to be simultaneously simulated for those sites. Dynamic aeroelastically-scaled models representative of typical large launch vehicles were constructed for testing. Aeroelastic scaling includes matching geometry, mode shapes, reduced frequencies, damping, running mass ratios, and running stiffness ratios. The models were tested in smooth uniform flow and then immersed in the atmospheric boundary-layer for comparison of these effects. Dynamic data were acquired measuring unsteady pressure, acceleration, and base bending moment. It was discovered that peak dynamic loads resulting from resonant wind-induced oscillation response are similar when acquired in either smooth uniform flow or an atmospheric boundary-layer. This indicates that resonant lock-in events are minimally impacted by representative turbulence and/or wind profile. Alternately, nonresonant wind-induced oscillation response events are stronger when acquired in an atmospheric boundary-layer. This indicates that a lowly-damped structural response will increase when exposed to an increased magnitude of random excitation, which is consistent with historical comparisons. Loads created by the resonant response events were substantially stronger than those from the nonresonant response events. Therefore, if testing is done to simply identify worst-case conditions and load magnitude, then smooth uniform flow is likely an adequate test technique. However, if nonresonant response loads are of primary interest, then atmospheric boundary-layer simulation is required.
Document ID
20200002975
Acquisition Source
Langley Research Center
Document Type
Conference Paper
Authors
Thomas G Ivanco
(Langley Research Center Hampton, Virginia, United States)
Donald F Keller
(Langley Research Center Hampton, Virginia, United States)
Jennifer L Pinkerton
(Langley Research Center Hampton, Virginia, United States)
Date Acquired
April 23, 2020
Publication Date
March 7, 2020
Publication Information
Publication: 2020 IEEE Aerospace Conference
Publisher: Institute of Electrical and Electronics Engineers
ISSN: 1095-323X
e-ISBN: 9781728127347
Subject Category
Launch Vehicles And Launch Operations
Aerodynamics
Report/Patent Number
NF1676L-33598
Meeting Information
Meeting: IEEE Aerospace Conference
Location: Big Sky, MT
Country: US
Start Date: March 7, 2020
End Date: March 14, 2020
Sponsors: Institute of Electrical and Electronics Engineers
Funding Number(s)
WBS: 484997.01.01.01.06.01
Distribution Limits
Public
Copyright
Work of the US Gov. Public Use Permitted.
No Preview Available