Enhancements to the CALIOP Aerosol Subtyping and Lidar Ratio Selection Algorithms for Level II Version 4

This presentation describes several enhancements planned for the version 4 aerosol subtyping and lidar ratio selection algorithms of the Cloud-Aerosol Lidar with Orthogonal Polarization (CALIOP) instrument. The CALIOP subtyping algorithm determines the most likely aerosol type from CALIOP measurements (attenuated backscatter, estimated particulate depolarization ratios de, layer altitude), and surface type. The aerosol type, so determined, is associated with a lidar ratio (LR) from a discrete set of values. In the version 3 algorithms, there are 6 pairs of 532 and 1064 nm lidar ratios. Some of these lidar ratios will be updated in the version 4 algorithms. In particular, the dust and polluted dust will be adjusted to reflect the latest measurements and model studies of these types. The algorithms are being updated to eliminate the occasional confusion between smoke and clean marine aerosols seen in version 3 by modifications to the elevated layer flag definitions that are used to determine the presence of smoke aerosols over the ocean. In the subtyping algorithms pure dust is determined by high estimated particulate depolarization ratios [de > 0.20]. Mixtures of dust and other aerosol types are determined by intermediate values of the estimated depolarization ratio [0.075< de <0.2]. The version 3 algorithms are limited to mixtures of dust and smoke, the so-called polluted dust aerosol type. To differentiate between mixtures of dust and smoke, and dust and marine aerosols, a new aerosol type will be added in the version 4 data products. In the revised classification algorithms, polluted dust will still defined as dust + smoke/pollution but in the marine boundary layer instances of moderate depolarization will be typed as dusty marine aerosols with a lower lidar ratio [LR = 35 sr] than polluted dust [currently LR = 55 sr]. The dusty marine type introduced in version 4 is modeled as a mixture of dust + marine aerosol. In the v3 algorithms the frequency of dust and polluted dust aerosols at daytime is higher than at nighttime. We present possible reasons for this and present the v4 distributions resulting from both improved background slope corrections of the daytime depolarization ratios and changes to the daytime thresholds for the polluted dust and dusty marine types of version 4. To gauge the impact of the enhancements, we contrast the following between versions 3 and 4: aerosol type, parameter distributions of each type, layer heights of maximum frequency, and distributions of smoke in biomass burning regions. To illustrate specific impacts the presentation shows case studies of version 3 and version 4 vertical feature masks of the aerosol subtypes, where appropriate, for the above enhancements.