Validation of Small Satellite Dynamics Simulation Modules using ASTERIA Flight Data

ASTERIA (Arcsecond Space Telescope Enabling Research in Astrophysics) was a CubeSat space telescope that operated in low-Earth orbit, having been deployed from the International Space Station in 2017. The spacecraft has achieved sub-arcsecond pointing stability and millikelvin thermal stability over 20-minute observations. A key enabling feature of the ASTERIA mission is the low level of pointing error that has been demonstrated under ASTERIA’s fine pointing control mode. Prior to launch, the ASTERIA mission performed analysis and simulations to estimate the in-flight pointing performance. This analysis used reaction wheel models provided by JPL’s Small Satellite Dynamics Testbed (SSDT), which had performed Kistler table testing to characterize the jitter caused by the reaction wheels of the Blue Canyon Technologies XACT attitude control unit within ASTERIA. These models were subsequently incorporated into the SSDT simulation. The main source of jitter, the high-frequency attitude disturbance over the camera exposure time, on ASTERIA is the set of rotating reaction wheels that are used for maintaining fine pointing during observations. The reaction wheels impart disturbance forces and torques continuously that cause unwanted motion during imaging. Increased jitter consequently leads to blurring of the image. Therefore, to benefit all SmallSat missions devoted to photometric or spectroscopic astrophysics applications, an on-orbit flight data acquisition and jitter testing campaign was performed in an attempt to help validate the SSDT’s simulation models. This paper describes the process used to validate several simulation models and attempt to characterize the ASTERIA jitter by analyzing the size of the resulting spot size for the target stars as a function of wheel speed, having commanded four wheel speeds for each of three stars of known brightness. After summarizing the on-orbit observation and jitter level measurement process, this paper compares the results obtained from the flight operational environment to the corresponding set of simulation jitter levels. Though the flight data obtained during this experiment was not sufficient to validate the simulation’s jitter model, other models have been validated with flight data, including the magnetic field, orbit propagation, sun position, and long-duration orbit decay models, which may be used by all other projects that use the SSDT’s simulation to increase system capability knowledge.