NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
A Dual Linear/Circular Polarized Wideband Flat Panel Phased Array Antenna for K/Ka-band 6U CubeSat Communications ApplicationsCircular polarized (CP) electromagnetic waves are preferred for space-to-space and space-to-ground satellite communications (SATCOM). CubeSats with 6U sizes (1U represents a 10 cm x 10 cm x 10 cm), that will rotate together with the Moon as it orbits Earth require high gain CP antenna systems to maintain reliable communication links. Here, we have designed an 8x8 dual linear and dual circularly polarized phased array antenna (PAA) aperture that offers 22-28 GHz bandwidth, with maximum gain of 23 dBic, and beam scanning capability of ±50o with acceptable axial ratio over all scan angles.

A stacked patch topology is selected to achieve wide impedance bandwidth. Each driven patch has two via feed point locations that are connected to grounded coplanar waveguide (CPW) feed structures. By utilizing phase shifters from the Anokiwave RFICs (AWMF-0165) employed for the beamforming network (BFN), we have generated both dual linear polarization and dual circular polarization in each patch. Each driven and parasitic patch is innovatively shaped to achieve excellent isolation between two feed points which, in turn, leads to low cross polarization, high efficiency and good axial ratio over the entire bandwidth.

Each chip has eight outputs which feed one 2x2 sub-array consisting of four dual linear or dual circularly polarized driven patches, simultaneously. Each 2x2 sub-array of the 8x8 array are sequentially rotated which improves axial ratio performance when the antenna operates in the dual circularly polarized mode. By utilizing a mirror effect, cross-polarized fields are also improved when operated in a dual linear polarized mode.

The 8x8 array aperture is simulated taking into account the effect of the multilayer printed circuit board (PCB) stack-up of the BFN and co-simulated with the power splitter outputs and chip outputs and results are compared with only passive array performance. The performance of the antenna is still excellent when non-ideal chip performances are included in the simulation analysis. The fabricated array will be tested for radiation patterns in the Antenna and Microwave Laboratory (AML) of the San Diego State University and the NASA Glenn Research Center (GRC) spherical near field chambers. The design of the 8x8 antenna array with BFN layout is shown in Fig. 1.
Document ID
20220009755
Acquisition Source
Glenn Research Center
Document Type
Presentation
Authors
Rudraishwarya Banerjee
(San Diego State University San Diego, California, United States)
Satish K Sharma
(San Diego State University San Diego, California, United States)
Sanghamitro Das
(San Diego State University San Diego, California, United States)
Seth W Waldstein
(Glenn Research Center Cleveland, Ohio, United States)
James M Downey
(Glenn Research Center Cleveland, Ohio, United States)
Bryan L Schoenholz
(Glenn Research Center Cleveland, Ohio, United States)
Sarah M Dever
(Glenn Research Center Cleveland, Ohio, United States)
James A Nessel
(Glenn Research Center Cleveland, Ohio, United States)
Date Acquired
June 24, 2022
Subject Category
Communications And Radar
Meeting Information
Meeting: 2022 IEEE Antennas and Propagation Symposium
Location: Denver, CO
Country: US
Start Date: July 10, 2022
End Date: July 15, 2022
Sponsors: Institute of Electrical and Electronics Engineers
Funding Number(s)
WBS: 582181.04.02.22.20.12.02
Distribution Limits
Public
Copyright
Use by or on behalf of the US Gov. Permitted.
Technical Review
Single Expert
Keywords
5G
phased array antenna
lunar relay
cubesat
ka-band
No Preview Available