Experimental Methods Using Force Application of A Single Boom for A 500-M²-Class Solar Sail

Solar sailing missions rely on deployable systems for large area-to-mass ratios once in space, while still being small enough for launcher envelopes in the stowed configuration. Many of these deployable systems feature booms that are flattened and subsequently coiled onto a spool / hub. As part of a collaborative deployable space structures research effort between the National Aeronautics and Space Administration (NASA) and German Aerospace Center (DLR), a boom deployment system for a future 500 m² solar sail has been developed. To achieve the respective solar sail size goal, 16.5-m-long booms produced by NASA were integrated into a DLR-designed deployer mechanism. This considerable size, as well as the lightweight construction of the booms and respective deployable systems makes testing on the ground a significant challenge. Some systems for gravity compensation as well as vertical testing to minimize the influence of gravity have been used in the past. However, an uncertainty factor remains towards the behaviour in the space environment. The focus of this paper is the load application testing of the integrated boom-deployment mechanism system under microgravity condition, as well as a comparison to vertical testing under gravity. Testing in microgravity was performed during a parabolic flight test inside an aircraft and it included stowage and full deployment of a single boom along the longitudinal axis of the aircraft. The load application was split into two categories: static testing, which induced a linear force ramp to the static boom for either compression or compression-bending; and dynamic testing, which applied a constant force to a boom during extension provided by the deployer mechanism. Both types of tests were performed multiple times at two distinct lengths of the boom, fully deployed (12.76 m) and ~28.6 % deployed (3.65 m). More parameters that are vital to the test philosophy are the angles of attack in the force application and the highest force applied. The data acquisition used for the applied load and deflection measurements of the boom is also presented.