Implementation of A New Microwave Scattering Database and A Forward Model for Active Microwave Sensors in CRTM

Radiative transfer models are extensively used for the assimilation of satellite observations into NWP models as well as retrieving geophysical products from satellite measurements. CRTM is a community model developed by NOAA JCSDA and widely used for different purposes requiring RT calculations. CRTM requires bulk scattering lookup tables in order to perform all-sky RT calculations. However, the current CRTM lookup tables for microwave frequencies were generated based on the Mie theory by assuming spherical frozen particles. The scattering lookup tables generated using the DDA technique has shown to largely improve the RT scattering calculations in the MW region. This presentation targets (i) the implementation and validation of a DDA database that was originally developed for the ARTS RT model into CRTM, and (ii) developing the CRTM active sensor module that takes advantage of the backscattering coefficients computed using the DDA method. The DDA database only provides single scattering properties of different habits, while CRTM requires bulk scattering properties. The CRTM cloud coefficients were previously generated based on the effective radius for representing the size of the particles. However, effective radius is neither measurable nor provided by the NWP models, thus need to be estimated from other geophysical variables such as water content. Therefore, in addition to calculating the CRTM bulk scattering properties from the DDA single scattering database, the CRTM was also largely modified to use cloud water content (kg.m-3), instead of effective radius, for performing the interpolation over size/mass of the particles. CRTM already requires water content as input, thus no extra variables are required for performing scattering calculations using the new ARTS DDA database. The CRTM scattering modules search for effective radius in cloud coefficient files and will use the cloud water content if the effective radius dimension is not found in the cloud coefficient files. Figure 1 shows the CRTM simulated brightness temperatures computed using different cloud coefficients versus ATMS observed values over Hurricane Irma on September 7, 2017 at 18:00 UTC. We used all the cloud water content values included in ERA5 with default CRTM/DDA habits for water, rain, snow, ice, hail, and graupel. ERA5 does not provide separate water content values for ice, hail, and graupel, thus the ice water content values were divided between ice, hail, and graupel clouds similar to what was explained in the previous section. In channels with a frequency lower than 90 GHz, emission from water and rain clouds can compensate for cloud scattering so that cloud contaminated Tbs are larger than corresponding clear sky Tbs. The DDA simulations for channels 1-7 largely perform better than the Mie simulations. The DDA simulations show a mix of small negative and positive simulated minus observed values, while the Mie results show large negative biases. The weighting functions for some of the ATMS temperature sounding channels (channels 9-15) peak mostly above the clouds, therefore the measured Tbs become less sensitive to clouds so that the results of both Mie and DDA become very similar. The Mie lookup tables generate excessive scattering for channel 16, but not enough scattering for the water vapor channels. In the specific case of Hurricane Maria, the DDA lookup tables do not generate enough scattering for channel 16, but the DDA results are much more consistent with observations for water vapor channels than for channel 16. It should be noted that the results may vary if we use other habits to represent snow, hail, and graupel in the DDA simulations. Although these results clearly show the advantage of the DDA database over the Mie dataset, different error sources such as error in the observations, displacement of clouds in the ERA5 reanalysis, and also lack of convective clouds or in general errors in the input atmospheric and cloud profiles contribute to the differences between the simulated and observed values. Aside from the improvements in the simulations, a major advantage of the new dataset is a large number of habits that can be used to tune the data assimilation systems to perform well in different weather conditions.