Space Exposure of Indium Tin Oxide Coatings

Indium tin oxide (ITO) coated thermal control samples were exposed to the space environment as part of the Materials International Space Station Experiment-9 (MISSE-9) mission to assess the impact of low Earth orbit (LEO) on material properties. Six samples were flown as part of the Polymers and Composites Experiment-1 (PCE-1): four samples of ITO coated silver Teflon (FEP/Ag/Inconel), and two samples of ITO coated Kapton HN (Kapton HN/Al). Samples were flown in ram, wake and zenith directions and were directly exposed to space for 0.77 years (ram) or 0.54 years (wake and zenith). Flight and corresponding control samples were tested post flight for changes in optical properties (total reflectance and solar absorptance) and film electrical resistance. In addition, the atomic oxygen erosion yield (Ey) was determined for each flight sample. This paper provides details on the flight sample materials, the mission space exposure and the postflight test results. Indium tin oxide coated samples were not significantly damaged by the LEO exposures. The atomic oxygen Ey values were very low and the solar absorptance changed very little. Sheet resistance of the ITO coated Kapton HN/Al doubled after ram exposure, however its final resistance of 10,820 Ohm/square is believed to be low enough to enable dissipation of electrostatic charges. Sheet resistance measurements for the ITO coated FEP/Ag/Inconel sheets suffered from high levels of scatter, with some resistance measurements higher than 370,000 Ohms/square.