The BATSE SLED: The problem and the correction

The Burst And Transient Source Experiment (BATSE) has been in space for 4 months and, by anyone's reckoning, is performing better than even the most optimistic pre-flight predictions. That doesn't mean there haven't been some small surprises. Because of the discreteness of gamma-ray energies available to us in pre-flight testing, we could not subject the instrument to the continuous distribution of energies it now sees in space. Therefore, it was not until the beginning of mission operations that a small non-linearity was discovered in the low energy region of the SPD spectra. The nickname for this depression is the SLED (Spectroscopy Low-Energy Depression). Sample spectra for module 6 at two gains (1X and 0.4X) are given. Note that the position of the sled is gain-independent in channel space. A further study on a non-flight module discovered the cause lay in the spectroscopy analog electronics. Above a certain energy threshold, the digital signal from the SPEC-FAST2 discriminator causes, in effect, an extra small amount of charge to be added to the SHER analog input. The laboratory measurements of SHER output energy as a function of input energy are presented. The change of slope at the point of the SLED results in narrower bin widths for the channels in that region. The SLED is approximately 5 channels wide. It should be mentioned that below the SLED and for many decades above the SLED the response is extremely linear. The proposed fix was to move the lower straight line up to match the extrapolation of the upper straight line, shown by the dotted line. In effect, this means reassigning channel numbers. All channel edges lower than the SLED are moved a fixed amount to higher channel numbers. Channel edges in the SLED are moved a different amount depending on their position. The latter obviously results in narrower channel widths in energy space.