NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
Ames Research Center Mars/Pathfinder Heat Shield Design Verification ARC-JET TestDesign verification tests were performed on samples representing the aerobrake of the Mars/Pathfinder vehicle. The test specimens consisted of the SLA-561V ablator bonded to the honeycomb structure. The primary objective was to evaluate the ablation materials performance and to measure temperatures within the ablator, at the structural bondline and at the back sheet of the honeycomb structure. Other objectives were to evaluate the effect of ablative repair plug material treatment and voids in the heat shield. A total of 29 models were provided for testing in the Ames 60MW arc-jet facility. Of these, 23 models were flat-faced and six remaining models were curved edge ones, intended to simulate the conditions on the curved rim of the forebody where the maximum shear occurred. Eight sets of test conditions were used. The stagnation point heating rates varied from 47 to 240 W/cm2 and the stagnation pressures from 0.15 to 0.27 atm. (The maximum flight values are 132 W/cm2 and 0.25 atm) The majority of these runs were made at a nominal stagnation pressure of 0.25 atm. Two higher pressure runs were made to check the current (denser) ablation material for spallation, or other forms of thermal stress failure. Over 60% of the flatfaced models yielded good thermocouple data and all produced useful surface recession information. Of the five curved-edge models that were tested, only one gave good data; the remaining ones experienced model-holder failure. The test results can be summarized by noting that no failure of the ablative material was observed on any model. Also, the bondline temperature design limit of 250 C was never reached within an equivalent flight time despite a stagnation point heat load that exceeded the maximum flight value by up to 130%. At heating rates of over 200W/cm2 and stagnation pressures of 0.25 atm, or greater, the average surface recessions exceeded 0.5 cm on some models. The surface roughness increased dramatically at pressures above 0.25 atm and was four times greater at 0.27 atm than at 0.25 atm. Procured repair plug material performed much better than room-temperature cured plugs, as observed in the previous tests. Voids in the ablator did not increase local temperatures and gaps did not grow during testing.
Document ID
20020038840
Acquisition Source
Ames Research Center
Document Type
Preprint (Draft being sent to journal)
Authors
Tran, Huy K.
(NASA Ames Research Center Moffett Field, CA United States)
Hui, Frank
(NASA Ames Research Center Moffett Field, CA United States)
Wercinski, Paul
(NASA Ames Research Center Moffett Field, CA United States)
Cartledge, Alan
(NASA Ames Research Center Moffett Field, CA United States)
Tauber, Mike
(Thermoscience Inst. Moffett Field, CA United States)
Tran, Duoc T.
(Thermoscience Inst. Moffett Field, CA United States)
Chen, Y. K.
(Thermoscience Inst. Moffett Field, CA United States)
Arnold, James O.
Date Acquired
August 20, 2013
Publication Date
January 1, 1995
Subject Category
Composite Materials
Funding Number(s)
PROJECT: RTOP 213-20-01
Distribution Limits
Public
Copyright
Work of the US Gov. Public Use Permitted.

Available Downloads

There are no available downloads for this record.
No Preview Available