NASA Logo

NTRS

NTRS - NASA Technical Reports Server

Back to Results
Landing Characteristics of a Reentry Capsule with a Torus-Shaped Air Bag for Load AlleviationAn experimental investigation has been made to determine the landing characteristics of a conical-shaped reentry capsule by using torus-shaped air bags for impact-load alleviation. An impact bag was attached below the large end of the capsule to absorb initial impact loads and a second bag was attached around the canister to absorb loads resulting from impact on the canister when the capsule overturned. A 1/6-scale dynamic model of the configuration was tested for nominal flight paths of 60 deg. and 90 deg. (vertical), a range of contact attitudes from -25 deg. to 30 deg., and a vertical contact velocity of 12.25 feet per second. Accelerations were measured along the X-axis (roll) and Z-axis (yaw) by accelerometers rigidly installed at the center of gravity of the model. Actual flight path, contact attitudes, and motions were determined from high-speed motion pictures. Landings were made on concrete and on water. The peak accelerations along the X-axis for landings on concrete were in the order of 3Og for a 0 deg. contact attitude. A horizontal velocity of 7 feet per second, corresponding to a flight path of 60 deg., had very little effect upon the peak accelerations obtained for landings on concrete. For contact attitudes of -25 deg. and 30 deg. the peak accelerations along the Z-axis were about +/- l5g, respectively. The peak accelerations measured for the water landings were about one-third lower than the peak accelerations measured for the landings on concrete. Assuming a rigid body, computations were made by using Newton's second law of motion and the force-stroke characteristics of the air bag to determine accelerations for a flight path of 90 deg. (vertical) and a contact attitude of 0 deg. The computed and experimental peak accelerations and strokes at peak acceleration were in good agreement for the model. The special scaling appears to be applicable for predicting full-scale time and stroke at peak acceleration for a landing on concrete from a 90 deg. flight path at a 0 deg. It appears that the full-scale approximately the same as those obtained from the model for the range of attitudes and flight paths investigated.
Document ID
20040035793
Acquisition Source
Langley Research Center
Document Type
Other - NASA Technical Note (TN)
Authors
McGehee, John R.
(NASA Langley Research Center Hampton, VA, United States)
Hathaway, Melvin E.
(NASA Langley Research Center Hampton, VA, United States)
Date Acquired
August 21, 2013
Publication Date
November 1, 1960
Subject Category
Launch Vehicles And Launch Operations
Report/Patent Number
NASA-TN-D-628
L-792
Distribution Limits
Public
Copyright
Work of the US Gov. Public Use Permitted.
No Preview Available