Application of Particle Image Velocimetry to a Study of Flow About a Multi-Element Airfoil

An experiment was performed on the flap tip vortex shed from a half span Fowler flap. This flap was mounted on a 5 foot span NACA 63(2)-215 Mod B airfoil in the 7 by 10 foot wind tunnel at NASA Ames Research Center. Several noise reduction studies were performed with this model, and the addition of the Particle Image Velocimetry (PIV) research discussed here served as a proof case of large scale PIV. The measurement plane investigated here was a cross plane region. This is cross plane relative to the freestream flow direction. The measurement plane was located at a position 18 inches downstream of the flap trailing edge. This served to prove that measurements could also be made in the more difficult cross plane direction rather than in the downstream flow direction. Lastly the PIV data was used as a practical research tool that yielded important results that could not otherwise be obtained. The flow field area measured was 40 cm by 40 cm square, and served to characterize the downstream flow characteristics of the flap tip vortex under three configurations: the baseline configuration which was the flap and the wing only; the baseline with the addition of a 3/4 span slat; and the baseline with a Flap Edge Device which was designed to reduce the noise generated at the flap. All configurations were tested at a freestream velocity of 64.84 m/s. The test resulted in average velocity fields for the three configurations tested. The velocity fields aided in verifying other testing methods on this particular experiment, and also yielded further insight into the characteristics of the flap tip vortex under the three configurations considered. The velocity data was reduced, and we were able to calculate the vorticity of the flow field. From the position of minimum vorticity the location of the center of the vortex was determined. The circulation was also calculated and aided in comparing the effects of the three configurations on the lifting characteristics of the flap.