Forward Flight Rotor Performance at Martian Atmospheric Densities and Sensitivity to Low Reynolds Numbers

Much effort has been made to enhance exploration on Mars. In addition to a rover and Mars-orbiting satellites, a Mars Helicopter Technology Demonstrator was proposed by the NASA Jet Propulsion Laboratory (JPL) to augment planetary research for the Mars 2020 Mission. Understanding rotor performance is vital for operations at Martian atmospheric conditions. The work presented is a study investigating rotor performance at Martian atmospheric conditions. Forward flight rotor tests were conducted in the Planetary Aeolian Laboratory (PAL) at NASA Ames Research Center, which has the capability to evacuate the air in the chamber to reach Martian atmospheric densities. A 1-meter-diameter rotor, roughly approximating the Mars Helicopter Technology Demonstrator, was tested at multiple atmospheric densities, including that of Mars. Rotor rotational speed, thrust, torque, power, and airspeed measurements were collected during the test. These results were then correlated with simulated cases using a mid-fidelity computational fluid dynamics software, Rotorcraft CFD (RotCFD). C81Generator (C81Gen) was used to generate airfoil aerodynamic coefficient for the spanwise locations along the rotor. To observe the differences between the C81Gen flow type modes at low Reynolds number, the simulations at Martian atmospheric densities were run under the “fully turbulent”, and the fully laminar flow type. In addition, Reynolds number effects (within 2x104 to 9x104) on experimental thrust coefficient, power coefficient, and figure of merit were analyzed. Within this chord- based Reynolds number range, CT and FM decreased around 26% and 36%, respectively, while CP remained fairly constant, exhibiting variations of no more than 5.5%. Despite the challenges involved in testing at a large difference of atmospheric ensities between Earth and Mars, repeatable data was obtained in all the measurements at Martian atmospheric conditions.